Skip to content

GameCube digital (GCVideo & co.)

The GameCube DOL-001 has a digital port (Digital AV Out) that exposes the raw digital video — a priceless gift: a simple adapter draws pixel-perfect HDMI from it, without opening the console. Common base: the GCVideo firmware.

Field Value
System GameCube DOL-001 (with digital port) — not DOL-101
Type HDMI from the Digital AV Out (digital video bus)
Level 🟢 plug-and-play (adapter) → 🟠 (soldered internal versions)
Reversible ✅ (external adapter)

The digital port: why it's special

The Digital AV Out on DOL-001s outputs video already digitised by the Flipper GPU. Adapters connect an FPGA (GCVideo) to it that encodes HDMI directly — no analog conversion, so a perfect image.

Check the model: DOL-001 vs DOL-101

The DOL-101 (late revision) lacks the digital port → these plug-and-play mods are impossible on it (only analog component/RGB remains, or a complex internal mod). Look under the console: DOL-001 = OK.

The products (all GCVideo-based)

Product Format Notes
Carby (Insurrection Ind.) external adapter plug-and-play, HDMI, good value
GCDual (Citrus3000psi) internal HDMI + analog RGB simultaneously, OSD
GCHD Mk-II (EON) external adapter mainstream, solderless
PixelFX G3 GEM / GCFX internal high-end, advanced scaling
GCVideo-DVI (DIY) internal/external open-source base firmware — many products derive from it

Installation

  • Carby / GCHD (external): clips onto the digital port. No soldering. 🟢
  • GCDual / PixelFX (internal): opening + soldering the flex onto the internal digital connector, HDMI output on the front. 🟠

Before / after

Criterion GameCube (composite/RGB) GCVideo (HDMI)
Signal analog digital HDMI
Sharpness fair (RGB) → blurry (composite) pixel-perfect
Modern TV hookup scaler required direct
Effort cable clip-on adapter

Where to buy

Alternatives

  • Native RGB (SCART cable) on DOL-001/101 — good, analog.
  • Console page: GameCube.

Sources & attribution

Review & corrections

How this space is used

Spotted a wrong value, an outdated procedure, a chip reference that does not match your board? Say so here, with what you observed (model, board revision, serial number, measurement). Every report is cross-checked against a source before anything changes — an unverifiable correction is published as “reported by …, not cross-checked” rather than silently applied.

Reading is open to everyone; posting requires signing in with Discord. Reports from the wiki's declared reviewers are handled first; anyone else's are read too, but go through a human before anything is changed.